How to Update Your Printer Firmware

 


 

1、Unzip the files

Unzip all the files inside the update zip package.

 

 

Notes.

Except for the UI file and logo file, all the files cannot change their names.

 

Document definition:

update.LCD:

The firmware file of the master chip, containing the firmware program and version number information.

chitu_initial_file_autorun:

Auto-run file list program, contains the list of files that need to be updated automatically.

xxxxxxx.gcode:

Machine parameters file, contains machine parameters or screen calibration parameters, etc.

xxxxxxx.bin:

In general, refers to the UI file.

xxxxxxx.logo

In general, refers to the logo file.

 

 

2、Copy files to USB flash drive

Copy all the files, into the USB drive and place them in the [root directory] of the USB drive.

 

Notes.

Place only in the [root directory], not in the folder.

 

 

 

3、Insert the USB drive into the machine

Power off the machine and insert the USB flash drive into the machine's USB port, followed by re-powering the machine.

 

 

4、Update Process

①、Firmware update

②、Other file update

 

After power on:

①、Firmware update

If the version of update.LCD in the U disk, and the current version on the controller board is not consistent, the controller board will take priority and automatically update this file, the touch screen will not light up at this time.

But you can hear the buzzer tone, buzzer tone rhythm for, Di-Di-Di-Di-Di-Di-Di~~~Di-Di.

(5 short beeps, 1 long beep, 2 short beeps)

After the firmware is updated successfully, the touch screen will light up and the program will start.

 

 

②、Other file updates

Then the controller board will automatically update the remaining files (except UI files, logo files), and display the update progress, when all the files to be updated are updated, the program will pop up [Print Complete] alert dialog.

 

 

Click the [Confirm] button, then you will enter the main page of the program, and all files (except UI files and logo files) have been updated at this time.

 

Notes:

If you need to update the UI file or logo file, then just print it manually.

 

 

 

What you need to do after the update is completed

After the update is completed, first unplug the USB flash drive, and then re-power the machine. At the same time, you need to remove all update files (except UI files and logo files) from the USB flash drive on the computer before the flash drive can be used normally on the machine.